Grabber's new Vector screw significantly reduces drive time and increases productivity with its much sharper and steeper-angled point compared to traditional framing fasteners. Competitive tests have demonstrated that Vector point screws drive up to eight times faster than IFI SAE J78 fastener penetration standards and 50% faster than competing fasteners. In a drive comparison with standard framing fasteners, the VectorTM performed considerably better across the board in multiple drive test comparisons.
CUT DRIVING TIME IN HALF
Designed specifically for metal framing, the Vector™ fastener drives through light-gauge metal with ease. Competitive tests compared the Vector™ screw against 9 other fasteners through two layers of 25-gauge metal—and the results were dramatic. The Vector™ screw performs eight times faster than IFI SAE J78 penetration standards—and 50% faster than the average time for other fasteners.
Specifications
- Gauge: #7
- Length: 7/16"
- Head Type: Pan Head
- Recess Type: #2 Phillips
- Thread Type: Twin lead
- Coating: Gray phosphate
- Point: Vector Point
Installation Guidelines
Use a standard screwgun with a depth-sensitive nose piece. Suggested screwgun specification for optimal performance – 4 amps minimum and RPM range of 0 to 4,000.
- The pan head is fully seated when the head is flush with the work surface.
- Overdriving my result in fastener failure or strip out.
- The fastener must penetrate beyond the metal three full thread pitches.
All GRABBER® screw products are manufactured in facilities that are ISO 9002 and ISO 14001 certified and approved.
Technical Data
Safety Data Sheet
